Tabla de contenido
Idiomas disponibles
Idiomas disponibles
< Temporarily setting the tool down while working >
It can be placed-upside down on the protrusion that is on
the top of the main body. (Fig. 27)
NOTE
Place it on a stable surface.
< Reusing used cartridges >
Rotate the end of the pin attached to the bottom of the
holder sideways to detach it, use it to scrape out and
remove any hardened parts from the nozzle or cartridge,
then reattach it to the holder. (Fig. 28)
NOTE
Be careful not to scratch the inside of the container
with the pin.
Pin
Hardened
sealing material
Protrusion
Rack handle
Fig. 27
Pin
Hardened sealing material
Fig. 28
5. LED light warning signals
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
activate during operation, the LED light will blink as
described in Table 7. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Safeguard
LED Light
Function
Display
On 0.1 second/off
Overload
0.5 second
Protection
OPERATIONAL CAUTIONS
Resting the unit after continuous work
After use for continuous works, rest the unit for 15 minutes
or so when replacing the battery. The temperature of
the motor, switch, etc., will rise if the work is started
again immediately after battery replacement, eventually
resulting in burnout.
English
Table 7
Corrective Action
Remove the cause
of the overload.
17
Tabla de contenido
