Velleman DVM205AM Manual Del Usuario página 7

4. Touc h the target sur rface with the e
the L LCD.
f) Period Measur P
1. Plug the black test le
2. Set t the selection sw
3. Conn nect the black tes st lead to ground
be m easured.
4. Read d the measured
NOTE: Th he applied time
g) P Pulse Width M
1. Plug the black test le
2. Set t the selection sw
3. Conn nect the black tes st lead to ground
be m easured.
4. Read d the measured
h) R RPM Measurem ments
1. Plug the black test le
(#11 1).
2. Set t the selection sw
on th he RPMx10 rang ge).
3. Conn nect the black tes st lead to the neg
the re ed test lead to a
4. Crank k the engine; the e RPM (rotations
i) D Dwell Angle Me
1. Plug the black test le
(#11 1).
2. Set t the selection sw
on th he DWELL range e).
3. Conn nect the black tes st lead to the neg
the re ed test lead to a
4. Crank k the engine; the e dwell angle wil
NOTE: The dwell ang
ignition system m. Cars with an
to have the dw well angle tested
7. Ma intenance
CAUTION N: Before openin ng the case, set
to avoid electric shock h hazard. Do not s
closed se ecurely.
If your D DVM205AM sho ould not be oper
not faulty y and are prope erly inserted.
a) I Install or Repl
The batte ery should be re eplaced when "B
and open n the case. Rem move the old bat
6F22 or e equivalent) - mi
b) R Replace a Fuse e
The fuse rarely needs to o be replaced; a
the screw ws at the back a and open the ca
250V/10A A fast blow for
Use this s device with o original access
event of f damage or in njury resulted
For mor e info concern ning this produ
The info ormation in thi is manual is su
© COPYR RIGHT NOTICE
This manu al is copyrighted.
No part of this manual may
the prior w written consent of
05.01.201 0
All manuals and user guides at all-guides.com
DVM20
xtremity of the
ements
ead in COM and d the red test lea
itch (#2) to "Pe eriod ms".
d and the red tes
value on the dis splay.
for most fuel in njectors is displa
easurements
ead in COM and d the red test lea
itch (#2) to "Pu ulse Width ms".
d and the red tes
value on the dis splay.
ead in COM and d the red test lea
itch (#2) to the e applicable pos
gative pole of the
breaker point.
s per minute) wil
easurements
ead in COM and d the red test lea
itch (#2) to the e applicable pos
gative pole of the
breaker point.
l be displayed.
le needs only be e tested in cars
electronic ignit
d.
t the selection s
switch the devic
rating properly,
ace a Battery
BAT" appears on
tery (when repl
ind the polarity ! Close the case
blown fuse is u
se. Replace the
10A range), clo se the case and
sories only. Ve
from (incorre
uct, please vis
ubject to chan
The copyright to o this manual is
be copied, reprod uced, translated o
the copyright hold der.
5AM
probe and read d the measured
ad in the + con nector (#11).
st lead to the wire e that connects t
ayed on the neg gative (-) slope.
ad in the + con nector (#11).
st lead to the wire e that connects t
ad in the + con nector
ition (2, 4, 5, 6 or 8CYL
e car battery and d connect
l be displayed.
ad in the + con nector
ition (2, 4, 5, 6 or 8CYL
e car battery and d connect
with a tradition nal
tion system don 't need
witch to OFF an nd disconnect al
ce on before the e battery/fuse co
check the batte ery and fuses to
n the display. Tu urn loose the sc
lacing) and insta all a new one (1
e and tighten th e screws.
usually the resu lt of the operato
e old fuse (250V V/0.5A fast blow
d tighten the scr rews.
elleman nv can nnot be held re
ct) use of this s device.
sit our website e www.vellema
nge without pr ior notice.
owned by Vellem man nv. All worldw
or reduced to any e electronic medium
7
temperature fro om
to the componen nt to
to the componen nt to
l test leads in o order
ompartment doo or is
o make sure the ey are
crews at the bac ck
1 x 9V-battery t type
or's error. Turn loose
w for 400mA ran nge;
esponsible in t the
an.eu.
wide rights reserve ed.
or otherwise with hout
©Vellema an nv