Battery Information; Operating Instructions; Standard 2-Hand Models; Quartz & Automatic - Movado Esq 101042 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

To help preserve the natural elasticity and quality
of a Series 800 ThermoResin™ or XTremeResin™
strap, rinse it using a soft cloth soaked in fresh
water following exposure to salt water, chemicals
or abrasive substances.
Use warm water and a neutral pH soap applied to
a soft cloth to gently clean a white Series 800
ThermoResilient™ strap; then wipe with a second
clean cloth dipped in warm water, or rinse
carefully under warm running water. Contact with
acetone and ethyl alcohol should be avoided.
NOTE: Movado watch straps are not covered by
the Movado watch warranty.

Battery Information

A Movado quartz timepiece has a 1.55 Volt
silver-oxide battery that is specially designed for
watches. It will last approximately 18-36 months
under normal use.
NOTE: Frequent use of special functions, like the
stopwatch timer on chronograph models, may
shorten battery life.
End-of-life feature: The seconds hand on many
models will start to move haltingly in 4-second
increments when the battery is almost exhausted,
signaling the need to have it replaced.
Battery replacement: It is important to use only the
replacement battery recommended by Movado.
Take or send your watch to an Authorized Service
Center to have battery changed – your old battery
will be disposed of/recycled properly. Do not
attempt to change the battery yourself.
All manuals and user guides at all-guides.com
10

OPERATING INSTRUCTIONS

Standard 2-Hand Models

Quartz and Automatic
Figure 1
Crown Positions:
Position 1 - Normal position.
Crown pushed into case.
Position 2 - To set TIME:
Rotate crown in either direction.
To manually wind an automatic
movement:
The motion of your arm during normal daily
activities should be sufficient to keep the
movement of your Movado automatic timepiece
wound. However, if you have not worn your watch
for more than 40 hours and the watch has
stopped, you will need to wind it by hand before
setting the time:
1. With the crown in position 1, turn the crown
clockwise approximately 20 revolutions.
2. Reset time following instructions above.
11
Tabla de contenido
loading

Tabla de contenido