Control Pads On The Dehumidifier; Indicator Lights; Control Pads - INVENTOR C2-10L Manual Del Propietário

All manuals and user guides at all-guides.com

CONTROL PADS ON THE DEHUMIDIFIER

The control panel of the dehumidifier you purchased may look like one of the following:

Indicator Lights

Power on (green)
Low fan speed on (green)(optional)
Bucket full (red)
Display
Shows the set humidity level, auto start/stop timer (0-24), or the
actual room's humidity level (+5% accuracy).
Error Codes:
AS- Humidity module sensor error--Unplug the unit and
plug it back in. If error repeats, call for service.
ES- Tube Temperature sensor error-- Unplug the unit and
plug it back in. If error repeats, call for service.
EC- Refrigerant leakage detection-- This new technology detects
refrigerant leakage and if this happens the EC code will appear,
call for service.
Protection Code:
P2- Bucket is full or not in the proper position--
Empty the bucket or place it in the proper position.
Auto defrost operation on (green)
Timer on (green)(optional)
Continuous operation on (green)

Control Pads

Continuos Operation Pad
Press this pad to set the dehumidifier to run
continuously (will stop if the bucket is full).To
cancel continuous operation just press this pad
again. Note: Humidity Set Control Pad cannot
be used during continuous operation.
TIMER Pad(optional)
Press to initiate the Auto start or Auto stop
feature, in conjunction with the ( - ) and ( + ) pads.
UP( + )/DOWN( - ) Pads
Humidity Set Control Pads
Press to set your desired humidity level within a
range of 35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the ( - ) pad to set a lower
percent value(%).
For damper air, press the ( + ) pad to set a higher
percent value(%).
TIMER Set Control Pads (on some models)
Use the Up/Down pads to set the Auto start or
Auto stop time (0-24).
SILENT Pad (optional)
Press to select either High or Low fan speed.
Set the fan control to High for maximum moisture
removal. When the humidity has been reduced
and quiet operation is preferred, set the fan
control to Low.
POWER Pad
Press to turn the dehumidifier on and off.
4
Control panel(1)
Control panel(2)