Dvr Web Connection - Urmet 1093/504A Guía Rápida

5.3

DVR WEB CONNECTION

Your DVR can be reached on the Internet (with or without DDNS) only if the Internet service supplier assigns a public IP
address (static or dynamic) to the router. It is therefore advisable to check this crucial detail with your Internet provider
beforehand.
1. DVR network parameter setup
The URMET DVR network configuration is DHCP mode by default (automatic IP address allocation):
a) If the network to which DVR is connected supports DHCP, simply display the parameters that the DVR acquires
automatically from the network in "Menu
allocated and appear automatically in the menu: IP address, subnet mask, gateway and DNS (see below).
Press APPLY to save the changes.
b) The DVR parameters must be allocated manually if the network does not support DHCP. Select "Type = Static"
on the "Menu Network" and fill in the following fields: IP address, subnet mask, gateway and DNS.
Press APPLY to save the changes.
IMPORTANT NOTE:
The DNS fields must be filled in correctly for correct operation of the DDNS system.
2. Port setup
At this point the external doors of the router must be forwarded to the DVR. The function is usually called "Port-forwarding"
or "Virtual Server" in the router configuration menu. The ports set on the router must correspond to those of the DVR.
a) Set different values on the DVR if the default ports of the DVR (80, 9000, 18600) are already in use in the port-
forwarding table of the router.
DS1093-119A
All manuals and user guides at all-guides.com
Network". Wait for ten seconds or so for the parameters to be
38