Technical Specifications - VONROC PH509AC Traducción Del Manual Original

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power
Power settings
Heating element type
Heating time
Wave length
Radiant efficiency
Heating distance
Heating area
Colour temperature
Overheat protection
Electronic soft start
Ingress protection class
Protection class
Weight
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Hanging chain
2. Power cable
3. Hanging hook
4. Carbine hook
5. On/off switch
6. Heater
7. Protective grill
8. Remote control
9. Remote control on/off button
10. Receiver for remote control with display
11. Down button
12. Up button
13. Timer button
14. Heat level button
WWW.VONROC.COM
PH509AC
220-240 V~
50-60 Hz
2000 W
1: 1000W
2: 2000W
Carbon fibre lamp
3 seconds
3.0-1000 microns
90%
2-3m
7-9m²
1600 K
Yes
Yes
IP44
Class I
2.36 kg
3. ASSEMBLY
This heater should be installed by a
competent person, i.e. a qualified electrician.
Always disconnected the heater from the
electrical supply and allow it to cool before
installation.
Installing the heater (Fig. A, C)
Always mount the device with the supplied
accessories.
Before starting the installation, take the following
into consideration:
• Place the device on a firm, level ceiling surface;
installation of the heater should be on a strong
rigid support (such as strong wooden beams or
metal rails etc).
• The device must be hung so that there is 50
cm of free space between the heater and any
ceiling, tent canvas etc. There must also be
at least 1.80 m between the ground and the
underside of the device. Refer to Fig. C. The
device can never be hung on a hook in the wall
as it could hang at a slant!
• The Hook used to hang the heater must be able
to take a weight 3 or 4 times that of the heater
itself.
• Ensure that the power supply cable is well
mounted and that it does not come into contact
with reflector of the heater or that does not trail
into heated area.
• Do not install the heater on an inflammable
surface.
• If the heater is to be used outside, a weatherp-
roof outlet is highly recommended.
• Before drilling ensure that there are no wires or
water pipes in the area where the heater is to
be installed.
To install the heater, follow these steps:
• The device is supplied with a hanging chain (1)
and two carbine hooks (4). Put a carbine hook
(4) on both ends of the chain (1).
• Mount one side of the chain onto the hanging
hook (3) using the carbine hook (4), as shown
on fig. A.
• Provide an attachment point from which the
device can hang down freely and that is sturdy
enough to hold the heater without any problems.
EN
5