Machine Information; Technical Specifications - VONROC PH516AC Traducción Del Manual Original

EN
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
This product is designed as a patio heater for
domestic environments. The heater is intended for
private gardens or other outdoor areas at home.
The heater may not be used to heat an indoor
space, usage as a non-household outdoor space
heater or for the drying of textiles or other mate-
rials. This heater is not equipped with a device to
control the room temperature so do not use this
heater in spaces when they are occupied by per-
sons not capable of leaving the room on their own,
unless constant supervision is provided. The device
is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power
Power settings
Heating element type
Heating time
Wave length
Radiant efficiency
Heating distance
Heating area
Colour temperature
Overheat protection
Electronic soft start
Tip-over safety switch
Ingress protection class
Protection class
Weight
6
. If you use an extension
2
PH516AC
220-240 V~
50-60 Hz
2000W
1: 1000W
2: 2000W
Carbon fibre lamp
3 seconds
3.0-1000 microns
90%
2-3m
6-8m²
1600 K
Yes
Yes
Yes
IP44
Class I
6 kg
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Heater
2. Power cable
3. On/off switch
4. Feet
5. Protective grill
6. Baseplate
7. On/off button
8. Timer button
9. Heat level button
10. Receiver for remote control
11. Remote control
12. Remote control on/off button
13. Remote control down button
14. Remote control up button
15. Remote control timer button
16. Remote control heat level button
17. Bolt
3. ASSEMBLY
Mounting the baseplate (Fig. A, C)
This heater should be installed by a
competent person, i.e. a qualified electrici-
an.
Always disconnected the heater from the
electrical supply and allow it to cool before
installation.
Always mount the device with the supplied
accessories.
Attach the heater (1) onto the baseplate (6) using
the supplied bolts (17), as shown on figure C. Only
use the heater with a correctly attached basepla-
te. It is not allowed to use the heater without the
baseplate.
Assembling the remote control (Fig. B)
• Flip the remote control (11) to the backside and
remove the battery cover.
• Insert 2 AAA/ Alkaline type batteries into the
remote control (11) in accordance with the
instructions and polarity of the batteries.
• Change the batteries in the same way depicted
above.
WWW.VONROC.COM