Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6
5.
If oil is still under the required level, check that the groove of the bar, the oil passage hole of
the bar and the oil dispensing area on the motor casing are clean and free from residue or
dirt. Clean the indicated parts if necessary and try again.
6.
Chainsaw with no oil: do not use the chainsaw without oil and contact your dealer or Sto-
cker Srl straightaway. Chain oil is essential.
Start-up inspection
1.
Make sure that nobody is within 15 metres of the workplace and watch out for animals.
2.
Start-up for the model with battery inserted (Figure 1): Align the battery pack „1" with the
slot of the tool board and push it until the battery pack locks and clicks.
3.
Start the machine, hold the handle „3", press the self-locking switch „4" with your thumb
and press the trigger „5". At this point, the display "2" turns on and the display content of
the screen is shown in "Figure 2" and the tool starts normally. (Note: the chain and the bar
must not come into contact with any object when starting the machine.)
190
Art. 318
Chainsaw Magma E-200 LA
Assembly
Art. 318
Chainsaw Magma E-200 LA
Usage
To be checked before use
Please check if the following aspects are in normal condition before operation:
1.
Ensure that the following parts and accessories are in good condition:
a. Chainsaw main unit
b. Bar
c. Chain
d. Battery pack
e. Battery charger
2.
Check the battery pack.
3.
The battery pack must be fully charged.
4.
Clean the chainsaw.
5.
Fit the bar and chain.
6.
Tighten the chain.
7.
Fill the special tank with chain oil.
8.
Check the control system.
9.
Check the lubricating oil pumping system.
For further information about the product, please contact [email protected]
7
191
Tabla de contenido
