Additional Safety Warnings - Bosch GDR18V-1860C Instrucciones De Funcionamiento Y Seguridad

2610067262 GDR GDS GDX18V-1860C 07-21.qxp_GDR GDX 7/16/21 7:30 PM Page 5
Safety Rules for Cordless Impact Drivers
Be prepared for a reaction torque when
"seating" or removing a fastener. The
screwdriver housing may tend to twist in
the opposite direction of bit rotation
when "seating" or removing a fastener
depending on the torque setting of the
tool.
Do not use dull or damaged bits and
accessories.
accessory, insert the shank of the bit
well within the chuck. Be sure the chuck
has locked onto the bit correctly.
Do not run the tool while carrying it at
your side. A spinning bit could become
entangled with clothing and injury may
result.
Place the tool onto the fastener only
when the screwdriver is switched off.
Rotating driver tools can slide off the
fastener.
Be careful when driving long screws –
there is a risk of sliding off the fastener
head depending on type of socket or
bit used. First test the run-down of a
GFCI and personal protection devices
like electrician's rubber gloves and
footwear will further enhance your
personal safety.
Do not use AC only rated tools with a
DC power supply. While the tool may
appear to
components of the AC rated tool are
likely to fail and create a hazard to the
operator.
Keep handles dry, clean and free from
oil and grease. Slippery hands cannot
safely control the power tool.
Develop a periodic maintenance
schedule for your tool. When cleaning a
tool be careful not to disassemble any
portion of the tool since internal wires
may be misplaced or pinched or safety
guard return springs may be improperly
mounted. Certain cleaning agents such
as gasoline, carbon tetrachloride,
ammonia, etc. may damage plastic parts.
Ensure the switch is in the off position
before inserting battery pack. Inserting
the battery pack into power tools that
have the switch on invites accidents.
When installing

Additional Safety Warnings

work, the electrical
fastener and pay attention during the
screw driving process to ensure you do
not injure yourself if the tool bit or
socket slides off of the fastener.
When Using Long Drill Bits
Never operate at higher speed than the
an
maximum speed rating of the drill bit.
At higher speeds, the bit is likely to bend
if allowed to rotate freely without
contacting the workpiece, resulting in
personal injury.
Always start drilling at low speed and
with the bit tip in contact with the
workpiece. At higher speeds, the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece,
resulting in personal injury.
Apply pressure only in direct line with
the bit and do not apply excessive
pressure. Bits can bend causing
breakage or loss of control, resulting in
personal injury.
Use vacuum system and protective gear
when drilling into materials which
generate dust.
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and
cement and other masonry products,
and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to
these chemicals: work in a well
ventilated area, and work with approved
safety equipment, such as those dust
masks that are specially designed to
filter out microscopic particles.
5
Some dust created by
power sanding, sawing,