Mounting Bracket; Down Rod Assembly; Canopy; Decorative Downrod Accessory - Craftmade Argos AG52 Instrucciones De Instalación

Preparation
Important: When using an existing outlet box, be sure the box is securely
attached to the building structure and can support the full weight of the fan.
Failure to do so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death. To
reduce the risk of shock, this fan must be installed with
an isolating wall control/switch.
2
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
IMPORTANT: If using the angle mount
method, check to make sure the ceiling
angle is not steeper than 35 º . Angles greater
than 35 º will require a 45 º angle adapter.
3
Check to make sure blades are at
least 30" from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
All manuals and user guides at all-guides.com
Downrod Installation
(Normal Ceilings)
Downrod Installation
(Vaulted Ceilings)
Step 3
84"
(2.1m)
Min.
4
Prior to securing mounting bracket, screw "J" hook (S11) into ceiling
outlet box as a secondary support means. Secure mounting bracket (#1)
to the outlet box (A) by tightening bracket screws & washers (S3) as
shown. If not mounting to an outlet box, use wood screws (S1) and
washers (S3) and mount securely to ceiling beam. Be sure at this point
to insert canopy screws (S2) in bracket.
sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S11)
Ceiling
Bracket Screws
& Washers (S3)
Wood Screws (S1)
5
Locate downrod assembly
(#2). Loosen ball screw on
black hanging ball to free
lock pin. Black hanging
ball will slide down.
Remove ground screw and
green ground wire. Remove
hanging ball from downrod
30"
and save all parts. Insert fan
0.75m
Min.
wires through downrod.
Slip on Canopy, Decorative
Downrod Accessory and
Flange Cover to the
Downrod. Screw Downrod
into top of fan motor
housing, being careful that
wires are pulled through.
Step 4
NOTE: Do not mount directly to
OUTLET BOX
Canopy Screws (S2)
Lock Pin
Step 5

Canopy

Downrod
Assembly
(#2)
Support Beam
Outlet Box (A)

Mounting Bracket (1)

Wood Screws (S1)
Green Ground
Wire
Ball Screw
Hanging Ball
Downrod
Decorative
Downrod
Accessory
Flange
Cover
Fan Motor Housing