Working With The Machine; Warning Signal; Service And Maintenance - Festool RTSC 400 Li Manual De Instrucciones Original

English
If the power tool is used in cordless opera­
tion with a mobile dust extractor, the bat­
tery life decreases. Reducing the suction
power minimises this effect.
High suction power can impair control of
the power tool. Reducing the suction pow­
er minimises this effect.
Recommendation: Use an antistatic suction
hose. This helps reduce the electric charge.
9.5 Edge protector [6]
The edge protector [6-1] prevents the sanding
pad circumference from coming into contact
with a surface (e.g. when sanding along a wall
or a window), thus preventing back-kick of the
machine, or machine damage.
Push the edge protector into the groove on
the machine.
Slot the two ends of the edge protector into
place until they click.
Loosen both ends of the edge protector.
Remove the edge protector by pulling it for­
wards.
6A
1
6-1
6B
1
6-1
10
6C

10 Working with the machine

Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
Observe the following instructions:
– Do not overload the machine by pressing
with excessive force! The best sanding re­
sults are achieved with moderate applica­
tion pressure. The sanding capacity and
quality are mainly dependent on the selec­
tion of the correct abrasive.
– Work in corners and on edges tends to sub­
ject the tip to increased stress and results
in increased heat development. In such
cases, work with reduced contact pressure.
– Hold the machine with one hand on the
handle [1-8].
2

10.1 Warning signal

The machine shuts down and makes a sound:
► Switch off the machine.
DTSC 400 Li
Battery pack is empty.
► Change the battery pack.
The machine shuts down and does not make a
sound:
Machine is overheated or has been overloaded.
► Switch off the machine for 30 seconds.
► Reduce the machine load.
2
If the machine's final speed is then not reached,
allow the machine to cool down.
RTSC 400 Li

11 Service and maintenance

Risk of injury, electric shock
► Always disconnect the battery pack from
the machine before any cleaning or main­
tenance!
4
WARNING
WARNING
3