Orbit 57894 Manual Del Usuario página 6

1. Select a Location
When choosing a location for your timer, consider the
following:
• Choose location near a power source (if hard wiring) or
electrical outlet (applicable only to U .s . retail timers)
• ensure operating temperatures are not below 32° or
above 158° Fahrenheit (below 0° Celsius or above 70°
Celsius)
• Place it away from direct sunlight if possible
• ensure at least 9" of space to the left of the sprinkler
timer box for the door to swing open after installation
• locate the timer where there is easy access to sprinkler
wire (from valves) . if mounted in an outdoor location,
shut the compartment door to keep the timer safe
from weather damage . To lock: insert the key and turn
clockwise to the locked position
Note: Sprinkler timers are weather-resistant to UL-50 and ETL
Listings, but should not be placed in areas where continuous
water could cause damage.
6
All manuals and user guides at all-guides.com
2. Mount the Timer
®
• Use the mounting template (included) to mark the
mounting screw location on the wall . See figure 1
• install a No . 8 screw (included) into wall in the upper
template location . leave the screw head protruding 1/8"
(3mm) from wall . Use expanding anchors (included) in
plaster or masonry, if necessary, for a secure hold
• slip the timer over protruding screw (using keyhole slot
in back of timer) . See figure 2
• drive a No . 8 screw through one of the two pre-formed
holes located in lower back cabinet . See figure 2
MOUNTING TEMPLATE
4.17"
GABARIT D`INSTALLATION
(106 mm)
GUIA DE COLGAR
3 dimensions:
proof no:
Figure 1: Use Mounting Template (included) fl at: w: 9" h: 7"
date:
10.05.07 fi nished: w 9" d: 0" h 7"
des: spck:
SM SM colors
job no: 07WTM005259
crop color
Registration non printing
client: Orbit
PMS
sku: 57880 K ????
p 801 295 9820
upc: ? ????? ????? ?
f 801 951 5815
additional instructions:
www.fl uid-studio.net ·
fi le name: 07WTM005259
·
1065 South 500 West 57880-04 rA.indd
Bountiful, Utah 84010 software: Illustrator CS2
Keyhole
Pre-formed
mounting holes
Figure 2: Hang timer on screw using keyhole
Printers are responsible for
meeting print production
requirements. Any changes must be approved by the
client and Fluid Studio.
printed piece must meet
color
non printing designated specifi cations
on this form.
PMS PMS
???? ???? © 2007 Fluid Studio. This
work is the property of Fluid
Studio, and cannot be used,
reproduced or distributed
in any way without their
express permission.
1/8"
No. 8 Screw
Wall