Idiomas disponibles
Idiomas disponibles
Note - QC 3.0, 2.0
• Plug & GO: no additional software required,
simply plug in and start:
Thanks to QC 3.0, 2.0, the voltage and power
are adjusted automatically.
• Be aware that, for efficient and optimised
charging, your terminal device must support the
QC 3.0, 2.0 function.
• If you have a large number of QC-enabled
devices with different firmware updates, it may
be that the function is not fully supported.
Unless different instructions have been expressly
given in the operating instructions for the devices
you are charging, proceed as follows:
• Connect your device to the USB charging socket
using a suitable USB cable.
• Then connect the charger to the on-board
electrical system's car socket.
• The charging process is displayed on your device.
• Disconnect the device from the charger if you wish
to interrupt the charging process or when the
device is fully charged.
• Then disconnect the charger from the line
connection.
When charging the rechargeable batteries in the
device, note the maximum charging times for the
built-in batteries.
Note - car battery
With some vehicles, it can happen that power
continues to be supplied even though the ignition
has been switched off. You should therefore
disconnect the product from the line connection
when not in use to protect your car battery from
being drained.
5. Care and maintenance
Only use soft, dry towels to clean the product.
Note
Disconnect the device from the mains before
cleaning and during prolonged periods of
non-use.
6. Technical data
Car charger
Vehicle electrical
system voltage
Output voltage /
current max.
Output power total
7. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
12 V, 24 V
5.0 V DC / 2.4 A / 12 W
12 W max.
3
