Date Of Manufacture - Asist AE4F120DN Instrucciones De Uso

too large. Or: Speed is too low.
Are milled surfaces turning dark? The milling head
became hot during work. Let it cool! Or: The feed is
too small. Or: The speed is too high.
Does the engine speed drop significantly during mill-
ing? Feed is too large. Work with less feed!
Is the engine running restlessly, is it stationary, or is it
difficult to start? Have the carbon brushes replaced by
authorized personnel.
Does the router heat up too much? Critical continuous
operation at full load. Take a break to cool down!
Specifications:
Input voltage 230 V
Input frequency 50 Hz
Power consumption: 1200W
Idle speed: 11000-30000 / min
Collet size: 6.8 mm
Max. milling depth: 55mm
Protection class / II.
Sound pressure level measured according to
EN 60745-1:
LpA (sound pressure) 89 dB (A) KpA = 3
LWA (acoustic power) 100 dB (A) KwA = 3
Take appropriate measures to protect your hearing!
Wear hearing protection whenever the sound pres-
sure level exceeds 80 dB (A).
Weighted rms acceleration value according to
EN 60745-1: 5.4 m / s2 K = 1.5
Caution: The vibration level may vary during power
tool operation from the declared value depending on
the way the power tool is used and depending on the
following conditions: Method of power tool use and
type of material being cut or drilled, conditions of the
power tool and method of its maintenance, appro-
priateness of the used accessories and ensuring its
sharpness and good conditions, the strength of handle
gripping, use of anti-vibration equipment, suitability of
the power tool for the purpose for which it has been
designed and compliance with workflows according to
manufacturer's instructions.
If this power tool is used in an inappropriate manner, a
hand/shoulder vibration syndrome may appear.
Caution: For clarification, it is necessary to consider
the level of vibrations in specific conditions of use in all
operating modes, e.g. the time when the power tool is
switched off except for the operation time, and when
it idles, i.e. performs no work. This may substantially
decrease the exposition level during the whole operat-
ing cycle.
Minimize the risk of vibrations, use sharp chisels, drill
and blades.
Keepthe power toolin compliancewith theseinstruc-
tions and provide for its proper lubrication.
When using the power tool regularly, invest into anti-
vibration equipment.
Do not use the power tool under temperatures lower
than 10°C. Plan your project containing work with the
power tool producing high vibrations carefully and
spread it over more days.
Subject to changes.
ENVIRONMENTAL PROTECTIONWASTE MA-
NAGEMENT
Power tools, accessories and packaging should be
provided for recycling and not to harm the environment.
Do not dispose of power tools into household waste!
According to Directive 2012/19/EU of the European
Parliament and of the Council on waste electrical and
electronic equipment (WEEE) and its approximation
in national laws, unfit power tools must be handed
over at the point of purchase of similar equipment, or
in available collection points designated for collection
and disposal of power tools. Such disposed power
tools will be collected, disassembled and delivered for
environment-friendly recycling.
WARRANTY
In the attached material, you will find our warranty
conditions.

Date of Manufacture

The date of manufacture is incorporated in the serial
number indicated on the product label.
The serial number has the format ORD-YY-MM-SERI
where ORD is the order number, YY is the year of
manufacture, MM is the month of manufacture, SERI
is the serial number of the product.
53