Start Up; Installation; Programming And Settings - Sagola PACK 6000X Manual De Instrucciones

10. Start up

10.1.- Installation

1.- Unpacking the equipment.
2.- Position it in its location.
3.- Attach the equipment to the wall.
4.- Connect it to the clean and prefiltered
compressed air grid.
5.- Ensure that the main switch (No.02) is in
the "OFF" position.
6.- Connect the heated hose.
7.- Connect the equipment to the mains
power supply.
8.- Move the switch to the "ON" position and check that the resistance activation pilot light does
not come on.
9.- By means of the buttons on the temperature controller (No.01) set the working temperature
between 30-40°C.
10.- Wait between 3 and 5 minutes, depending on the environmental conditions to heat the hose
11.- Start working. Check that the "Ready" pilot light turns on and off when stops are made with
a cut-off in air consumption.
12.- Pay special attention to the "Ready" pilot light and do not work when the "Ready" pilot light
is off.
To work with a more even temperature it is recommended to not make stops long (more than 2
minutes) during the work.

10.2.- Programming and settings

The desired temperature value is programmed by means of the push buttons on the temperature
controller as follows:
Modify the value of the desired temperature by means of the push buttons. To ensure proper
programming of the temperature, this must be higher than the ambient temperature.
The equipment is configured to operate at a maximum temperature of 70°C.
To change the learning parameters or the temperature range of the prepared pilot, you first need
to unlock the safety parameters of the controller. The way to unlock the controller is as follows:
- Press "SEL" for 1 second ("LoC 5" appears on the display).
- Press "SEL" again so that the display flashes.
- Press the down arrow until the value "LoC 0" is set.
- Press "SEL" again so that the display stops flashing.
- Press "SEL" for 1 second to exit the menu.
ENGLISH