Installation Of The Appliance - Tristar KB-7645 Manual De Usuario

Instruction manual
• Unplug the appliance from the socket when you are not using it.
• Do not use this appliance near direct heat sources.
* Competent qualified repair service: after sales department of the producer
or importer or any person who is qualified, approved and competent to
perform this kind of repairs in order to avoid all danger. In any case you
should return the appliance to this repair service.
The hybrid coolbox is suitable for mobile use. It's equipped with two
independent cooling systems. The device features a cooling system cooled
by a fan and a cooling system which drives on a compressor.
In the thermo-electric mode (connection to 12V) the appliance is able
to cool down the content up to 20 °C below ambient temperature. In
compressor mode (connection to 230V), the appliance is able to cool
down to -15 °C.

inStallation of the appliance

• Install the appliance on a firm, horizontal surface. To level the
appliance, use a spirit level or a vessel containing water, if necessary.
Avoid installing the appliance in direct sunlight or near any source of
heat. The distance between the rear of the appliance and a wall shall
not be less than 10 cm, and the minimum ventilating space from the
sides of the appliance shall never be less than 5 cm. In all cases, the
location shall be protected from rain and splashing. To guarantee a
good level of air circulation, do not obstruct the ventilation grids of the
upper, lower or rear surface of the appliance.
• Complying with the above will ensure efficient and economical
cooling.
• Before the first use of the appliance, clean the inside and the cover of
the appliance with warm water, adding detergent if necessary. Never
use an abrasive product.
4
• On boats: If your appliance is connected to the mains, please make sure
that the power supply is protected by a earth leakage circuit breaker.
operation with the mainS
• Check that the mains voltage corresponds to the operating voltage
specified on the label (on the rear of the appliance).
• If the electrical specifications are correct, push the safety electrical
plug into an earthed wall socket which is wired according to the
specifications.
connect the unit only as follows:
• With the DC cable to a DC power outlet in the vehicle (for example a
cigarette lighter)
• Or with the 230V cable to the 230V AC mains.
caution! risk of damage.
• Use the unit at one power source at a time. The simultaneous use of the
thermoelectric cooling system and the compressor is not allowed.
Start-up
• Turn the thermostat knob clockwise to the MAX position. In the
compressor mode, the temperature can be set from + 10 °C to -15 °C. In
the thermo-electric mode, it's not necessary to set the temperature.
• In the thermo-electric mode (connection to 12V) the appliance is able
to cool down the content up to 20 °C below ambient temperature. In
compressor mode (connection to 230V), the appliance is able to cool
down to -15 °C.
• The effects of the cooling process (frost on the evaporator) only
become visible after about an hour.
• After a sufficient cooling period (approximately a ½ hour), the
thermostat can be set to an intermediate position. The selected
temperature is regulated automatically by the thermostat.