Troubleshooting List - Aesculap Acculan 4 TPLO Instrucciones De Manejo

Aesculap
TPLO saw GT666
9.

Troubleshooting list

►
Have defective products repaired by Aesculap Technical Service, see Technical Service.
Issue
Product not running
Product becomes too hot Excessive use
Insufficient power
Loud running noise
Lid cannot be
attached/removed
14
Acculan 4
®
Cause
No battery
Battery not charged
Battery defective
Product in locked OFF position Safety catch is in OFF position
Product defective
Reprocessing/maintenance
carried out incorrectly
Fall damage, product defec-
tive
Blunt tool
Product defective
Blunt tool
Defective product drive/ball
bearings
Lid not compatible
Lid deformed/defective
Connection to product
deformed/defective
Detection
No battery in the battery shaft
No signal tone when inserting the bat-
tery
No signal tone when inserting the bat-
tery
Product not running
Product heating
Product heating
Product heating
Heating of tool and product
Insufficient product performance
Large amount of heat generated after a
short time
Tool blades worn out
Loud, perceptible noise during opera-
tion
Lid does not click into place
Lid is difficult or cannot be
mounted/removed
Lid is difficult or cannot be
mounted/removed
Remedy
Insert battery.
Charge battery in charger.
Have the manufacturer repair the battery.
Turn the safety catch into the ON position.
Have the manufacturer repair the product.
Follow operating instructions (operating
mode).
Follow operating instructions (preparation,
care).
Preventative: lubricate product before every
sterilization.
Have the manufacturer repair the product.
Change tool.
Follow operating instructions (preparation,
care).
Preventative: lubricate product before every
sterilization.
Have the manufacturer repair the product.
Follow operating instructions (operating
mode).
Have the manufacturer repair the product
Change tool.
Follow operating instructions (preparation,
care).
Preventative: lubricate product before every
sterilization.
Have the manufacturer repair the product
Use the compatible lid for GT666.
Have the manufacturer repair the lid.
Have the manufacturer repair the product.