Worx HYDROSHOT WP650E Manual Original página 13

TROUBLESHOOTING
Symptom
Machine turns on but it
does not draw any water
or there is not sufficient
pressure.
Machine does not start.
Machine stops
automatically.
Machine does not draw
any water after long time
storage.
Machine sprays
improperly.
Machine is "spitting".
Spraying performance
is weak
Machine runs for a short
period then shuts off.
20V Sanitizing pressure washer
Possible causes
The water inlet is loose.
The filter screen is missing. (See Fig.
L1, L2)
The battery pack is not attached well.
Battery pack is empty.
Defective battery.
Battery pack is empty.
Additional air could be sucked into
the machine.
Nozzle is clogged, hose is partially
disconnected, or fluid in tank is low.
Liquid in tank is too thick to spray
out.
Filter needs to be cleaned.
Solution is too thick.
Battery needs charging.
Solution is too thick.
Solution
Retighten the water inlet.
Contact Worx service agent to get a filter
screen.
Reinstall the battery pack.
Replace with a new battery pack or recharge the
battery pack.
Replace with a new battery pack.
Replace with a new battery pack or recharge the
battery pack.
It is recommended to pour water directly into
the hose adapter with the machine turned on
to empty the air. Ensure water sprays out of the
nozzle before working.
Clean the filter. Check hose connections
and make sure there is sufficient fluid
in the tank.
Empty the tank, clean both the tank and filter,
then try again. Make sure that all liquid used in
the sprayer are as thin as water.
Clean the filter.
Make sure that all liquid used in the
sprayer are as thin as water.
Recharge the battery.
Make sure that all liquid used in the
sprayer are as thin as water.
13
EN