KTM 22112929044 Instrucciones De Montaje página 35

7.1 Optional locking cylinder for the cover lock
Installing the locking cylinder
–
Insert springs
E
.
Info
The kit contains many small parts. It is recommen-
ded that you perform the assembly while seated at
a table.
500644-01
–
Insert tumblers
chambers
500645-01
–
Insert the ignition key and check whether the tumblers
with number 1 are correct.
All tumblers close flush with the locking cylinder.
–
Replace the non-matching tumblers with ones that have
the matching number.
Tip
It is recommended that you note the numbers of
the matching tumblers so that the subsequent
locking cylinders can be equipped immediately.
500517-01
–
Repeat the steps for chambers
first six chambers are fitted with the correct tumblers.
–
Insert the ignition key.
All tumblers close flush with the locking cylinder.
500518-01
–
Grease and mount O-ring
Long-life grease (
–
Position and insert the locking cylinder as shown (engaging
bo
plate
Engaging plate
–
Pull up the locking device.
–
Position locking plate
the locking cylinder as shown.
500660-01
The plate faces to the right and the opening to the
front.
bn
(included) into chambers
bm (included) with the number 1 into
A C E
, , and .
B D
,
6
(included).
p. 17)
must point to the right).
bo
engages.
3
(included with the topcase) on
OPTIONAL 7
A C
, , and
F
, and until the
15