Machine Information; Technical Specifications - VONROC BC501AC Traducción Del Manual Original

EN
mains power has the required 230 V~ 50 Hz,
neutral lead, a 16 A fuse and an ELCB switch
(earth leakage circuit breaker)! Ignoring this
advice may damage the device.
• Do not place the charger close to fire, heat and
prolonged temperatures over 50 °C! The output
power of the car charger automatically drops In
higher temperatures.
• Ensure no fuel lines, electric cables, hydraulic-,
water pipes are damaged by the screws whilst
assembling the charger! Otherwise there is
a risk of death or injuries!
• Only use the car charger with the included
original parts!
• Do not cover the car charger with objects! Igno-
ring this advice may damage the device.
• Protect the surfaces of the battery's electrical
contacts from short circuiting!
• Only use the car charger for charging and main-
tenance charging undamaged 6 V- / 12 V leada-
cid batteries (with electrolyte solution or gel)!
Otherwise material damage could occur.
• Do not use the car charger for charging or
trickle charging non-rechargeable batteries.
Otherwise material damage could occur.
• Do not use the car charger to charge or trickle
charge a damaged or frozen battery! Otherwise
material damage could occur.
• Before connecting the charger, refer to the bat-
tery' s original operating instructions for battery
maintenance information! Otherwise there is
a risk of injury and / or damaging the device.
• Before connecting the charger to a battery
permanently connected to a vehicle, refer to the
vehicle's operating instructions for information
about maintaining electrical safety and mainte-
nance! Otherwise there is a risk of injury and/or
property damage.
• Also disconnect the car charger from the mains
when not in use for environmental reasons!
Remember standby operation also consumes
electricity.
• Always be alert and always be careful what you
do. Always proceed with caution and do not
operate the car charger when unconfused or
feel unwell.
6

2. MACHINE INFORMATION

Intended use
This device is designed to charge a variety of SLA
(sealed lead-acid) batteries primarily used in cars,
motorcycles and some other vehicles. Supported
battery types are Regular, Deep cycle, Gel or AGM
lead-acid batteries. The special design of the de-
vice allows the battery to be charged to near 100%
of its capacity.

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
Reverse current (no AC input)
Rated output voltage
Charging current
Supported battery types
Supported battery capacity
Ingress protection
Jump start current
Jump start use interval
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. DISPLAY button
2. BATTERY TYPE button
3. MODE button
4. Negative (-) terminal clamp
5. Positive (+) terminal clamp
6. Digital display
7. Power cord
8. Fuse with cover
3. OPERATION
Remove the mains plug from the mains
socket before performing any work on the
battery charger. Risk of electric shock!
Danger of damage to property! Risk of
injury!
BC501AC
230V~
50Hz
350W
<5mA
6V / 12V
2A / 6A / 15A +/-10%
Regular / Deep cycle /
Gel / AGM
8-210Ah
IP20
75A max.
3s ON / 180s OFF
WWW.VONROC.COM