Waeco PerfectView RV-FM-10 Instrucciones De Montaje página 20

_RV-FM-10.book Seite 20 Mittwoch, 11. Januar 2006 11:03 11
All manuals and user guides at all-guides.com
Safety and installation instructions
When the negative terminal of the battery is disconnected, all volatile
memories in the convenience electronics lose the stored data.
The following data must be set again, depending on vehicle equipment:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following instructions during installation:
Fasten the modules in such a way that they cannot become loose under
any circumstances (sudden braking, accidents) and cause injuries to the
occupants of the vehicle.
To prevent damage, when drilling ensure that there is sufficient room for
the drill head to emerge once the hole has been made (fig. 2, page 3).
Grind all drill holes and treat them with rust-protection agent.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 2) or a voltmeter (fig. 1 9, page 2).
Test lamps with an illuminant (fig. 1 12, page 2) take up voltages which
are too high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (fig. 3,
page 3).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insula-
ting tape, for example to existing cables.
20
PerfectView