Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: Risk of injury!
1. Disconnect the mains plug from the wall socket.
2. Only open the appliance after the pressure has been
released. Press the steam button to do so.
3. If the appliance is still warm, wait approx. 5 minutes until
removing the lid.
4. Press down the lid and turn it anticlockwise to remove.
5. Pour any remaining water from the boiler in order to avoid
overfilling.
6. Use the funnel to fill the boiler with a maximum of 600 ml of
water.
7. Attach the lid by turning it clockwise and applying pressure
at the same time.
Installation of accessories
•
You have the option of attaching the individual nozzles
directly onto the handle. Insert the accessory onto the
handle until the button (7) clicks into place. To release the
accessory, press the button (7) on the handle.
•
The extension pipes enable you to work in large or high ar-
eas. Insert them into each other until the button on the pipe
clicks into place. Attach the pipe to the handle as described
above. To separate the pipes, press the button on the pipe
again.
•
If you want to clean sensitive floor surfaces, also attach the
fleece cloth to the floor brush.
•
For joins, fixtures and fittings or hard to reach areas, screw
the round brush onto the jet nozzle attachment.
Electrical Connection
•
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
•
Connect the device to a duly installed protective contact
socket.
WARNING:
• Always remove the mains plug before cleaning the device.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
Before you begin cleaning you should test the materials to
be cleaned as to their suitability for cleaning with steam. Do
not hold the steam nozzle for too long and too close in one
position.
1. To switch on the appliance, set the on/off switch to position I.
2. Pressure starts building up in the boiler after approx.
6 minutes.
3. Press the steam button to generate steam.
NOTE:
•
After a long period of non-use, it is normal that a small
amount of condensation, which has formed in the pipe,
will leak out at first.
•
Using the appliance with the maximum water amount
and in continuous operation will allow for steam genera-
tion of up to 15 minutes.
Filling the Water Tank during Operation
No steam will be discharged if the water tank is empty. The
water has to be filled up as follows:
1. To switch off the appliance, set the on/off switch to position
O.
2. Remove the mains plug from the socket!
3. Fill fresh water into the tank as described in the chapter "Fill
in Water" (steps 1-6).
4. Connect the plug to the socket again and switch the appli-
ance on to continue operation.
When you have finished using the device
1. To switch off the appliance, set the on/off switch to position
O.
2. Remove the mains plug from the socket!
3. Let the unit cool down completely.
4. Empty the water tank.
Cleaning
Using the Device
27
Tabla de contenido
