Thrustmaster T-GTII Manual página 10

ATTENTION:
- Do not remove the foam pads located on the underside of the racing wheel's base! The foam
pads amplify the effects of the T-DFB system when the wheel is attached.
- The textured rubber side of the mounting discs (26) must imperatively be positioned facing the
cockpit shelf = never position the metal side facing the cockpit shelf.
Attaching the racing wheel to a table or a desktop
1. Place the racing wheel on a table or any other horizontal, flat and stable surface.
2. Insert the fastening screw (14) in the attachment system (13), then tighten the device by turning the
screw anticlockwise, so that it feeds into the large threaded hole (12) located beneath the racing
wheel, until the wheel is perfectly stable.
ALWAYS
WARNING:
- Never tighten the screw alone, without the attachment system in place (this could damage the
racing wheel).
- Do not remove the foam pads located on the underside of the racing wheel's base! The foam
pads amplify the effects of the T-DFB system when the wheel is attached.
NEVER
9/16