Intended Use; Inserting/Changing The Batteries - Dremel 3Z Instrucciones De Funcionamiento Y Seguridad

2610067140 3Z Laser Measurer 02-21.qxp_Layout 1 2/24/21 8:01 AM Page 1
Digital laser measure: The measuring tool is intended for measuring dis-
tances, lengths, heights and clearances, and for calculating areas. The
measuring tool is suitable for measuring indoors.
Tape adapter: The tape adapter is intended for use in combination with
the 3Z Laser Measurer for measuring circumferences (e.g. of vases, pipes,
etc.) and lengths of freestanding objects (e.g. televisions, shelves, etc.) in
interior areas.
Wheel adapter: The wheel adapter is intended for use in combination with
the 3Z Laser Measurer for measuring distances between two points (e.g.
lengths of material) in interior areas.

Inserting/changing the batteries

It is recommended that you use alkaline batteries to operate the measuring
tool.
– Insert the batteries (see figure 1). When inserting the batteries, ensure that
the polarity is correct according to the illustration on the inside of the bat-
tery compartment.
The battery warning (h) is shown on the display when the battery voltage
is weakening.
When the battery symbol first appears on the display, measurements can
be made for approx. another 15 minutes.
When the battery symbol flashes, you have to replace the batteries because
measurements are no longer possible.
Always replace all batteries at the same time. Only use batteries from
one brand and with identical capacity.
Remove the batteries from the laser measure when not using it for ex-
tended periods. When storing for extended periods, the batteries can cor-
rode and discharge themselves.
Do not use lithium-ion batteries. This may result in damage to the
measuring tool.

Intended Use

Assembly
11