Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
Blow Tube Assembly (Fig. E)
WARNING:
without tube securely in place. Never reach down into
housing through tube hole.
WARNING:
remove the battery pack when you leave blower
unattended or when storing, checking, adjusting,
cleaning, or working on blower.
1. To attach the blower tube
up the peg
7
of the power head with the notch
blower tube opening as shown in Fig. E.
2. Push the blower tube onto the power head until the
tube locks engage the blower tube and an audible click
is heard.
3. Pull on the tube to ensure it is securely in place.
4. To remove the blower tube, squeeze both tabs
side of the power head and pull the blower tube off.
OPERATION
WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
WARNING:
without blow tube securely in place. Never reach down
into housing through tube hole.
WARNING:
glasses. Always wear respiratory protection. Always
wear hearing protection. Use of rubber gloves and
substantial footwear is recommended when working
outdoors. Keep long hair and loose clothing away from
openings and moving parts. For household use only.
WARNING:
the tool off, wait 10 seconds for the fan to stop rotating
before removing the blower tube.
•
Always ensure the blower is switched OFF and the
battery is removed when:
‑
You leave blower unattended.
Clearing a blockage.
‑
‑
Checking, adjusting, cleaning or working on blower.
•
Only use blower in daylight or good artificial light.
Proper Hand Position (Fig. G)
WARNING:
personal injury, ALWAYS use proper hand position
as shown.
8
Do not operate blower
Always turn unit off and
3
to the power head
6
, line
8
9
on the
To reduce the risk of serious
Do not operate blower
Always wear safety
Cut Hazard. When turning
To reduce the risk of serious
WARNING:
personal injury, ALWAYS hold securely in anticipation
of a sudden reaction.
Proper hand position requires one hand on the main
handle
2
.
Inserting and Removing the Battery Pack
from the Tool (Fig. A, F)
WARNING:
battery, make certain the trigger switch
of the
position to prevent switch actuation.
nOTE: Make sure your battery pack
To Install the Battery Pack into the
Tool Handle
Align the battery pack
handle (Fig. F).
Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap into place.
To Remove the Battery Pack from
the Tool
Press the release button
out of the tool handle.
Insert battery pack into the charger as described in the
charger section of this manual.
Switching ON/OFF (Fig. A, H)
WARNING:
product firmly when switching on.
CAUTION:
self or bystanders.
Your blower is fitted with a 2 speed ON/OFF switch located
on the top of the main handle
•
To switch the blower ON, slide the ON/OFF
forward to position 1.
•
To operate blower in high speed, slide the ON/OFF
switch forward to position 2.
•
To switch the blower off, slide the ON/OFF
switch back.
MAINTENANCE
WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
Your CRAFTSMAN power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
To reduce the risk of serious
Before removing or installing
1
4
is fully charged.
4
with the rails inside the tool's
5
and firmly pull the battery pack
Use both hands to grip the
Do not point unit discharge at
2
.
1
1
To reduce the risk of serious
is in the off
switch
1
Tabla de contenido
