Assemble The Guide Bar And The Chain; Install The Battery Pack; Remove The Battery Pack; Operation - Cramer 2000986 Manual De Instrucciones

EN
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt enters
in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. A completely filled oil tank will last for 15 - 40 minutes
operating time.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
3.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 1-7.
1. Remove the chain cover nuts with the wrench.
2. Remove the chain cover.
3. Put the chain drive links into the bar groove.
4. Put the chain cutters in the direction of the chain

operation.

5. Put the chain in position and make sure that the loop is
behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket.
8. Make sure the chain tension pin hole on the guide bar fits
correctly with the bolt.
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the nuts when the chain is well tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
3.4

INSTALL THE BATTERY PACK

Figure 2
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
IMPORTANT
NOTE
WARNING
English
3.5

REMOVE THE BATTERY PACK

Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Remove the battery pack and keep hands clear of the lock
out button when you move the machine.
Examine the chain tension before each use.
4.1 EXAMINE THE CHAIN
LUBRICATION
Do not use the machine without sufficient chain lubrication.
Figure 1
1. Examine the lubricant level of the machine from the oil
indicator.
2. Add more lubricant if it is necessary.
4.2

HOLD THE MACHINE

Figure 8
1. Hold the chainsaw with one hand at the rear handle and
with the other hand at the front handle. Always use both
hands when using the machine.
2. Hold the handles with the thumbs and the fingers around
them.
3. Make sure that the thumb of the hand that holds the front
handle is below the handle.
4.3

START THE MACHINE

Figure 1.
1. Press the lock-out button.
2. Press the trigger while you hold the lock-out button.
3. Release the lock-out button.
The chain brake must be disengaged for the chain saw to
start. Activate the brake by moving the front hand guard
forwards.
4.4

STOP THE MACHINE

Figure 1.
1. Release the trigger to stop the machine.
6
NOTE
IMPORTANT
NOTE
IMPORTANT