Robern CRAFT Serie Instrucciones De Instalación página 3

INSTALLING THE MIRROR
1. Unpack all parts and place them on a protected work surface. Refer to the mounting bar requirements (below) making sure that all
requirements are met when installing the mounting bar.
• At least one screw MUST be installed in a structural member (stud, etc.)
• All mounting screws must be used in mounting bar.
2. Determine the exact location of the fixture and mark holes on the wall surface using the holes as a guide. Make sure that the
mounting bar is level when securing it to the wall.
3. Drill pilot holes in each mounting location on the wall. When necessary, the holes should be large enough to accommodate wall
anchors (not included).
NOTE: Wall anchors appropriate to the wall type must be inserted in any location where a structural member isn't available.
4. Where needed, insert wall anchors into the holes in the wall.
5. Use the mounting screws to secure the mounting bar to the wall. Tighten until there is strong resistance. DO NOT OVERTIGHTEN.
NOTE: At least one screw MUST be installed in a structural member (stud etc.)
© 2021 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
3
Part no. CB-209-1403 07/14/2021
Craft Series Mirror