Skil 1144 Manual Original página 7

incorrect operating procedures or conditions and can be
a) Maintain a firm grip on the power tool and position
your body and arm to allow you to resist kickback
forces. Always use auxiliary handle, if provided, for
maximum control over kickback or torque reaction
during start-up.
taken.
b) Never place your hand near the rotating accessory.
c) Do not position your body in the area where power
tool will move if kickback occurs. Kickback will propel
d) Use special care when working corners, sharp
edges etc. Avoid bouncing and snagging the
accessory.
tendency to snag the rotating accessory and cause loss
e) Do not attach a saw chain woodcarving blade or
toothed saw blade.
GENERAL
16 years
making any adjustment or changing any accessory
Do not work materials containing asbestos (asbestos
is considered carcinogenic)
ACCESSORIES
when the correct accessories are used which can be
smaller than M14 x 21 mm
OUTDOOR USE
BEFORE USE
220V supply)
without it
reactions and/or respiratory diseases to the operator or
3
bystanders); wear a dust mask and work with a dust
extraction device when connectable
as oak and beech dust) especially in conjunction with
work with a dust extraction device when
connectable
materials you want to work with
Secure the workpiece (a workpiece clamped with
by hand)
DURING USE
hands and take a secure stance
AFTER USE
standstill
WHEN CONNECTING NEW 3-PIN PLUG (U.K. ONLY):
USE
! disconnect the plug
- mount auxiliary handle A as illustrated and tighten
both screws supplied with hex key B
! disconnect the plug
- clean spindle C and all parts to be mounted
- screw VELCRO backing pad D onto spindle C while
pushing spindle-lock button E
! push spindle-lock button E only when spindle C
is at a standstill
backing pad D
tightened
7
wear a dust mask and
3 in order to
5
6