Setting Up/Operation - Stadler Form Max Manual De Instrucciones

All manuals and user guides at all-guides.com
• For indoor use only.
• do not store the appliance outdoors.
• the heater is fitted with a safety thermal cut-off which will switch off
the appliance.
• the heater must not be located directly below a power outlet.

Setting up/operation

1. Having set up MaX heater in the desired position, insert the mains cable
(6) to the household supply socket.
2. Switch on MaX to the desired level by means of the rotary control (1).
3. rotary control (1):
Position 0 = Off
Position = Ventilation, turn the room-thermostat rotary
Position i = Heating, 750 w
Position ii = Heating, 1500 w
4. room thermostat (2): the room-thermostat control (2) allows for a vari-
able temperature adjustment.
Setting: For maximum temperature turn the control clockwise, for mini-
mum temperature, turn the control anticlockwise.
recommendation: turn the thermostat control (2) clockwise as far as
the stop. if the desired room temperature has been reached, turn the
thermostat control (2) anticlockwise until the appliance switches off.
if the room temperature drops, then MaX switches on again automati-
cally. Please note that after the thermostat switches off automatically, it
takes a few minutes for the heater to switch on again!
*
5. Frost-protection circuit
prevent the room temperature from falling below approx. +5°C, set the
rotary control (1) to position i or ii (depending on the size of room, Position
ii for larger rooms) and the room-temperature control (2) to
ance switches on automatically at approx. +5°C and off again at approx.
+7°C. in this way, frost damages can be avoided.
6. Protection against over-heating: MaX is fitted with an over-temperature
safety device which switches off the appliance in the case of a technical
fault or improper use. Should this occur, pull the mains cable (6) out of
the supply socket and remedy the fault or correct the method of use. the
appliance can be put back into use when it has cooled down and has been
disconnected from the mains supply for a short time.
Note: Make sure that there is always sufficient space between the
appliance and the wall or other large objects. The air flow must not
be blocked by objects of any kind.
Cleaning
Before servicing the appliance and after each occasion of use, switch off
the appliance and unplug the mains cable from the socket.
• Attention: never immerse the appliance in water (danger of short-cir-
cuit).
• to clean the appliance, only wipe it down with a damp cloth and then dry
it carefully.
• take care that the air intake and outflow grilles do not become exces-
sively dusty; clean them occasionally with a dry brush or vacuum cleaner.
control (2) clockwise as far as the stop
: Set the room-thermostat control (2) to
*
. to
*
. the appli-