Summary Of Device Labels Containing Safety Information; Technical Specifications; Correct Usage - Rupes RX153A Instrucciones De Funcionamiento Y Mantenimiento

TECHNICAL SPECIFICATIONS

TYPE
Ø Orbit [mm]
Ø Backing Pad [mm]
Backing Pad Thread
Holes Backing Pad
R.P.M
Electronic speed control
Power [W]
Insulation Class
Weight [Kg] according to EPTA-procedure
The values shown are based on a nominal voltage of 230V/50Hz. In case of voltages and frequencies of
different power values may vary. Refer to the label technical specifications to the values of the tool.
WARNINGS
The safety and accident prevention instructions are reported in the "SAFETY INSTRUCTION" booklet which
is an integral part of these documents. This operating instructions manual indicates the additional
information required for the specific use of the tool.

CORRECT USAGE

This tool is designed to be used as a sander. Read all safety warnings, instructions,
indications provided on drawings and specifications provided with this tool. Failure to comply with
all instructions provided
This tool is not intended to be used for metal brushing, polishing and cutting operations. The use
of this tool for
The tool must be used with accessories that have been specifically designed or recommended by
the manufacturer. The fixing of the accessory to the tool does not guarantee a safe operation.
The rated speed of the accessories must be at least equivalent to the maximum speed specified on
the tool. Using the accessories at speeds above the rated one, may cause them to break or be thrown into
the air. The external diameter and thickness of the accessories must match the specifications of
the tool. Accessories with incorrect dimensions cannot be adequately protected or controlled.
The configuration of accessories must match the tool. The use of accessories that cannot be
perfectly fitted on the tool may result in imbalance, excessive vibrations and in the impossibility of controlling
the tool. Do not use damaged accessories. Before use, inspect all the accessories. Inspect the
supporting pads and verify there are no cracks, tears or excessive wear. If the tool or accessory has
fallen, verify that it is not damaged or install a new accessory. After inspecting or installing an
accessory, test the operation of the tool at maximum speed and without load for one minute,
keeping at a safety distance. If the accessories are damaged, they will break during this test.
8

Summary of device labels containing safety information

WARNING: To reduce the risk of injury, user must read instruction manual
Wear ear protection
Wear gloves
Disposal of decommissioned (WEEE Directive)
Arrow – act in the direction indicated by the arrow direction
below may
unintended applications
CE mark for EU market
RX153A/RX253A
RX153A
3
150
5/16"
MULTIHOLE
4000 ÷ 10000
•
250
I
1.2
cause electrical shocks,
may cause
Wear eye protection
Wear a mask
RX156A/RX256A
RX156A
MULTIHOLE
4000 ÷ 10000
fire and/or
hazards and injuries
GB
6
150
5/16"
•
250
I
1.2
serious injuries.
to people.