Num'axes PIE1023 Manual De Instrucciones página 29

Other
Settings
Language
Date/Time
Time stamp
Battery Type
Frequency
Cycle recording on
the memory card
Factory settings
Password
Product information
8. Setting up the camera
− Mount the camera facing north or south, not east or west as the rising and setting of the sun could
produce false triggers and overexposed images.
− If you're covering a trail, face the camera down or up the trail.
− Clear out any brush or weeds in front of the camera. These can cause false triggers due to
temperature and motions disturbances in front of the camera (especially in windy days).
− Check the power level of the batteries.
− Make sure the memory card is properly inserted and have sufficient available space.
− Verify time and date are correct.
− Make sure to turn the camera ON before leaving (switch in the ON position).
9. Technical specifications
Image sensor
Effective pixels
PIE1023 avec carte SIM NUM'AXES - Indice E – Mars 2022
Programmable options (default settings in bold characters)
Français | English | Español | Deutsch | Italiano | Portugês | ...
DD:MM:YY | HH:MM:SS
Manually set date/time.
NOTE: it is important to set the date and time to ensure some functions work
as expected (for example: time stamp on the photos, sending time of the daily
report, operation during defined time period).
ON | OFF
Select "ON" if you want the date and time of the image capture imprinted on
every photo. The current temperature, moon phase and user set camera ID
will also be imprinted on the still photos.
Alkaline | Ni-MH (nickel-metal hydride)
The device will perform better if you indicate the type of the batteries
installed in the camera.
50Hz | 60Hz
An improper setting may cause the camera screen to flicker.
OFF | ON
When the memory card will be full, the camera will continue to record
photos/videos by deleting the oldest photos/videos.
Select "OFF" then press OK to deactivate the cycle recording function.
No | Yes
Select "Yes" to reset the camera back to the factory default settings.
OFF | ON
Select "ON" then press OK to enable password protection for your camera
(6 digits/letters).
This parameter shows the following information: Ver | IMEI | MCU
5 Mega Pixels Colour CMOS
2560 x 1920 pixels
29/96