Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE
Camshaft adjusting tool (3)
These tools are used to lock the camshafts in position.
Access must first be gained to the blanking plugs that are
positioned one on the front of the cam cover and one on the rear
of the cam cover. Lift the high pressure fuel rail and engine
wiring harness to gain access.
Remove the blanking plugs and screw the locking tools into
place with the flats on the inner section of the tools horizontal.
The tools are correctly fitted when the inner section of the tools
can be easily pushed in with finger pressure.
Note: These tools are for setting the position of the camshafts.
Do not attempt to loosen or tighten any fixings on the camshaft
using these tools to lock the camshaft as damage will result.
Chain tensioner lever (4)
This tool is used to clamp the timing chain when replacing the
gasket on the one-piece cylinder head. The tool is attached in
alignment with the inspection opening on the engine control
cover so that the pin acts upon the ribs of the chain slider.
Retract the chain tensioner piston so that it moves back to its
locked position using the lever.
Ensure the tensioner has fully extended before attempting to
retract it.
Crankshaft locking tool (5)
This tool is used to set the control position of the crankshaft
(flywheel end) with engine removed when a complete engine
rebuild is required. The tool is attached to the crankshaft using
the three fasteners (From Item 1) in place of the flywheel.
Always follow the vehicle manufacturers' instructions.
Crankshaft setting tools (2/6)
Pin 8mm (2) for Fiat – Pin (6) for Opel or Suzuki
The flywheel alignment pins are used to lock the position of the
flywheel to ensure the crankshaft is in the correct timed position
to match the camshafts.
Note: These tools are for setting the position of the crankshaft,
do not attempt to loosen or tighten any fixings on the crankshaft
using these tools to lock the crank as damage will result.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
