Operation; Display; Setting The Pressure; Switching On And Off - Mistral MSP 12 A1 Traducción Del Manual De Instrucciones Original

Operation

NOTE
► The appliance vibrates during operation.
Therefore, always put it down during opera-
tion. There are four feet
the appliance for this purpose.
ATTENTION!
►
This appliance is not designed for continuous
operation. The appliance may be used for a
maximum of 10 minutes continuous operation.
Allow the appliance to cool down completely
and then try using it again.
♦ Select the accessories you need.
♦ Remove the hose
is secured for transport and storage with the
elastic band .

Display

♦ You can switch between "bar", "psi" and "kpa"
on the display by pressing the selection
button .
■ 6 │ GB │ IE │ NI
on the bottom of
from the appliance. This

Setting the pressure

♦ Press the "+" button
set the desired pressure.
TIP
► If you press and hold down the "+" button
or the "-" button
changes quickly.
NOTE
► The compressor switches off automatically
when the preset pressure has been reached.
Switching on and off
Switching on the appliance
♦ Press the ON/OFF switch
Switching off the appliance
♦ Press the ON/OFF switch

Setting up

Inflating/deflating
♦ Fit the locking connection of the hose
the desired adapter. To inflate, use the inflation
connection . To deflate, use the deflation
connection .
♦ Turn it clockwise until it is fixed firmly in place.

Attachments

♦ Screw the adapter
tion of the hose anticlockwise until it is fixed
firmly in place.
♦ Screw the adapter
connection of the hose
fixed firmly in place.
♦ Push the desired adapter into your SUP board
and follow the manufacturer's instructions.
High-pressure attachment
The high-pressure attachment makes it easier to fill
SUP boards.
The middle seal, which is preassembled on the
adapter, is used as standard.
If air leaks occur during operation, please use the
thickest gasket. If you cannot insert the attachment
into the object, please use the thinnest seal.
or the "-" button to
, the pressure setting
.
again.
onto
onto the adapter connec-
or onto the adapter
clockwise until it is
MSP 12 A1