Replacing Carbon Brushes - Makita KP0810 Manual De Instrucciones

Ocultar thumbs Ver también para KP0810:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

When doing a great amount of chamfering, place an
edge of chamfering rule so that it contacts workpiece
and make many passes of planing as shown in the
figure.
a
b
007828
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the rear cover.
1
007651
Take out the worn carbon brushes, insert the new ones
and secure the rear cover.
1. Edge of
1
chamfering rule
1. Limit mark
1
1. Screwdriver
2. Rear cover
2
1
007652
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
High-speed steel Planer blade
Tungsten-carbide Planer blade (For longer blade
life)
Mini planer blade
Sharpening holder assembly
Blade gauge
Set plate set
Edge fence (Guide rule)
Dressing stone
Dust bag assembly
Elbow
Socket wrench
Chamfering rule assembly
9
1. Carbon brushes
or
attachments
Only use
accessory or
are
Tabla de contenido
loading

Tabla de contenido