Install Wiring Harness; Positioning Canister - Leer PACE EDWARDS ULTRAGROOVE ELECTRIC Instrucciones De Instalación

Hardware Used:
Hardware Used:
HARDWARE
USED:
Wire Harness x1
Wire Harness x1
Zip Ties x5
Zip Ties x5
• If installing the product on your own, place the Canister in truck bed just behind the cab and center it
from side to side. You will need to place the canister on elevating objects, such as the box the canister
came in or 5 gallon buckets.
ardware Used:
e Harness x1
6
p Ties x5
STEP 3: INSTALL WIRING HARNESS
• From inside the truck bed, push the long wire harness end without the
plug through the stake pocket on the drivers side of the truck and out the
underside of the truck bed box.
• Leave approximately one foot of slack inside the box for mounting the
electronics.
• Route the wire harness under the truck, and to the battery in the engine
compartment.
• Attach the fuse holder to the end of the RED/positive wire.
(Do not attach to the battery yet.)
• Secure the harness with zip ties provided after slack from the canister
had been taken out.
STEP 4: POSITIONING CANISTER
(If you have someone to help, you can jump to step 5 and install
the assembled canister and rails on the truck.)
Note: Ensuring that the canister is centered in the bed will help
assemble the rails to the canister in the next step.
Canister needs to be
high enough to have
rail install clearance
Canister needs to be
high enough to have
rail install clearance
Canister needs to be
high enough to have
rail install clearance
Elevating
Objects
FIG. 4A
Elevating
Objects
Elevating
Objects
FIG. 4A
FIG. 4A