Installing Kickstands - Leer PACE EDWARDS ULTRAGROOVE ELECTRIC Instrucciones De Instalación

• Another way to check proper fit is to test the side to side play of the handle assembly at the canister and
at the tailgate end of the rails. There should be, at the minimum, enough play to allow the cover to move
freely with no drag and at a maximum 1/8 inch per side. More than 1/8 inch per side may result in the
cover opening unintentionally and in severe cases it may fall between the rail tracks and damage the cover.
There are "Stick on Shims" on the shim brackets that can be removed if the unit is too tight
and "Stick on Shims" in the hardware pack that can be added if too loose. Refer to Figure 8C
for "Stick on Shims" if adjustment is needed.
Adjusting
Bolt
FIG. 10B
Shorter Orientation
Flipping
Base
Shorter Orientation
STEP 10: INSTALLING KICKSTANDS
FIG. 10A
Pivot
Flat
Foot
Washer
Lock
Washer
FIG. 10C
Kickstand Base
Adjusting
Bolt
Pivot
Flat
Foot
Washer
Longer Orientation
FIG. 10C
FIG. 10B
• Install the kickstands at the tailgate ends
of the rails. Loosely fasten the kickstand
assembly to the clamp grip, on the side
of the grip where the pivot foot will land
on the flattest section of bed wall. You
may have to use the right or left side of
the clamp for the pivot foot to land on the
flattest section of the bed wall. Rotate the
assembly so that it will push as squarely as
possible on the bed wall, then tighten the
wing nut. If the assembly is not positioned
squarely against the bed wall, the assembly
will rotate out of position, or the foot can
dislodge when the rail is flexed or loaded
(FIG. 10C).
• Run the adjusting bolt inward toward the
Wing Nut
bed wall, putting some pressure on the
foot, then continue running the bolt inward
using torque wrench to tighten to 70 in-lb.
(5.9 ft-lb.) until the rail is visually level. The
FIG. 10A
adjusting bolt can be removed and the
base flipped 180 degrees to adjust
for varying clearance with the bed wall
(FIG. 10B). Verify the BR dimension
after the rails are leveled.
Wing Nut
Lock
Washer
Flipping
Base
Adjusting
Bolt
Pivot
Foot
FIG. 10B
Shorter Orientation
F
Flat
Washer Loc
Washe
FIG. 10C
13