Instructions For Maintenance - IRUDEK MINIBLOK Serie Manual De Instrucciones

•
Climatic exposure,
•
Pendulum falls,
•
Extreme temperatures
•
Chemical reagents,
•
Electrical conductivity
-It is essential for the safety of the user that if the product is re-sold outside the original country of
destination the reseller shall provide instructions for use, for maintenance, for periodic examination
and for repair in the language of the country in which the product is to be used.
LIFETIME
The estimated product lifetime is 11 years from the date of manufacture (1 year storage + 10 years
for use). The following factors can reduce the lifetime of the product : intense use, contact with
chemical substances, specially agressive environment, extreme temperature exposure, UV exposure,
abrasion, cuts, violent impacts, bad use or maintenance.
The required annual examinations will validate the correct functioning of the equipment. It is
compulsory that the equipment is examined by the manufacturer or his authorized representative at
least once a year.
In case that it have been used to arrest a fall, the equipment must be withdrawn from use.
TRANSPORT
The Personal Protective Equipment must be transported in a package that protects it against
moisture or mechanical, chemical and thermal attacks.

INSTRUCTIONS FOR MAINTENANCE

- CLEANING: The personal protective equipment must be cleaned without causing
adverse effect on the materials used in the manufacture of the equipment. For textile (
webbing and ropes ) and plastic parts wipe with cotton cloth or a soft brush. Do not use any
abrasive material. For intensive cleaning wash the harness at a temperature between 30ºC
and 60ºC using a neutral detergent. For metallic parts wipe with a wet cloth. When the
equipment becomes wet, either from being in use or when due to cleaning, it shall be allowed
to dry naturally, and shall be kept away from direct heat.
- STORAGE: Personal protective equipment should be stored loosely packed, in a dry
and well- ventilated place, protected from direct light, UV degradation, dust, sharp edges,
extreme temperature and aggressive substances.
REPAIR
Any repair shall only be carried out by equipment manufacturer or his authorized representative
following manufacturer's procedures.
MARKING The equipment is marked with the next information :
i ) CE marking, Conformity to European Legislation
ii ) Identification of the manufacturer
iii ) Reference of the equipment
iv ) Lot number or serial number
v ) Year of manufacture vi ) European Norm vii ) Notified body number