IRUDEK MINIBLOK Serie Manual De Instrucciones página 10

Always avoid twisting of the webbing. During use, make sure that the webbing does not rewind
with a twist.
Avoid letting the retractable type fall arrester become entwined beneath your arms or legs, or avoid
that the webbing come into contact with rough surfaces or sharp edges likely to cause cuts or
abrasions
HOW TO USE – MINIBLOK
Follow Step 1 to 3 to use the equipment MINIBLOK :
1. Connect the equipment to the anchorage point through the
connectorIrudek 1135 (EN 362) supplied in the top part of the fall
arrester. It is recommended that the anchor point where the fall arrest
system is going to be fixed should always be placed above the position
of the user, should have a minimum static strength of 12kN and should be
in conformity to EN 795 requirements. The shape and construction of
the anchor point should not let self-acting disconnection of the device.
2. Connect the connector Irudek (EN 362) supplied on the extremity of the
webbing, to the back anchorage or front anchorage point of the harness
(EN 361).
3. Make sure the connectors are properly locked.
HOW TO USE – TWINIBLOK
Follow Step 1 to 4 to use the equipment TWINBLOK :
1. Use the connector Twinconnect 111 to connect 2 MINIBLOK,and make a twin equipment,
TWINBLOK.
2. Install the connector Twinconnect 111, on the back anchorageplate webbing of the harness
(EN 361),
3.Connect the connector Irudek (EN 362) supplied on the extremity of the webbing, to the structure.
4. Make sure the connectors are properly locked.
INSPECTION
- During pre-use check it is necessary to inspect all elements of the
equipment in respect of any damages, excessive wear, corrosion,
abrasion, degradation due to UV, cuts or misuse, especially take
into account the body and components of the fall arrest device,
webbing, locking mechanism functioning, anchorage rings and
connectors.
-Before each use verify the locking function by pulling strongly
the webbing, the fall arrester should block and prevent it from
unwinding. When you release the webbing, it must rewind freely. -
Take out the webbing to check for possible failures and signs of
cuts. Check that it rewind and it is stored correctly.
-Check that the energy absorber is correctly packed in its case.
-Check the correct function of the connectors and their locking.
LIMITATIONS FOR USE
- Personal protective equipment should be a personal issue item
- It is recommended that the anchor point where the fall arrest
system is going to be fixed should always be placed above the