Instructions For Maintenance - IRUDEK PRO11 Manual De Instrucciones

WARNING : The training must be conducted without exposing the trainee to danger. Training must be repeated on a
regular basis.
INFORMATION & ADVICE
- A rescue plan shall be in place to deal with any emergencies that could arise during the work.
- It is forbidden to make any alterations or additions to the equipment without the manufacturer´s prior written consent.
- Personal protective equipment shall not be used outside its limitations, or for any purpose other than that for which it
is intended. - Before use ensure about the compatibility of items of equipment when assembled into a system. Ensure that all items
are compatible and appropriate for the proposed application. It is forbidden to use combinations of items of equipment
in which the safe function of any one item is affected by or interferes with the safe function of another. Periodically
check the connection and adjustment of the components to avoid accidental disconnection and loosening.
- Personal protective equipment must be withdrawn from use immediately when any doubt arise about its condition for
safe use and not used again until confirmed in writing by a competent person that it is acceptable to do so.
- Personal protective equipment must be withdrawn from use immediately when it have been used to arrest a fall.
- It is essential for safety to verify the free space required beneath the user at the workplace before each occasion of use,
so that, in the case of a fall, there will be no collision with the ground or other obstacle in the fall path. The required
value of the free space should be taken from instruction manual of used equipment.
- There are many hazards that may affect the performance of the equipment and corresponding safety precautions that
have to be observed during equipment utilization, especially:
•
Trailing or looping of lanyards or lifelines over sharp edges,
•
Any defects like cutting, abrasion, corrosion
•
Climatic exposure,
•
Pendulum falls,
•
Extreme temperatures
•
Chemical reagents,
•
Electrical conductivity
-It is essential for the safety of the user that if the product is re-sold outside the original country of destination the
reseller shall provide instructions for use, for maintenance, for periodic examination and for repair in the language of
the country in which the product is to be used.
LIFETIME
The estimated product lifetime is unlimitated. The following factors can reduce the lifetime of the product: intense use,
contact with chemical substances, specially agressive environment, extreme temperature exposure, UV exposure,
abrasion, cuts, violent impacts, bad use or maintenance.
The required annual examinations will validate the correct functioning of the equipment. It is compulsory that the
equipment is examined by the manufacturer or his authorized representative at least once a year.
In case that it have been used to arrest a fall, the equipment must be withdrawn from use.
TRANSPORT
The Personal Protective Equipment must be transported in a package that protects it against moisture or mechanical,
chemical and thermal attacks.

INSTRUCTIONS FOR MAINTENANCE

- CLEANING: The personal protective equipment must be cleaned without causing adverse effect on the
materials used in the manufacture of the equipment. For textile (webbing and ropes) and plastic parts wipe
with cotton cloth or a soft brush. Do not use any abrasive material. For intensive cleaning wash the harness at a
temperature between 30ºC and 60ºC using a neutral detergent. For metallic parts wipe with a wet cloth. When
the equipment becomes wet, either from being in use or when due to cleaning, it shall be allowed to dry
naturally, and shall be kept away from direct heat.
- STORAGE: Personal protective equipment should be stored loosely packed, in a dry and well - ventilated
place, protected from direct light, UV degradation, dust, sharp edges, extreme temperature and aggressive
substances.
- LUBRICATION: lubricate moving parts frequently with a silicone-based lubricant. Avoid spilling oil on
textile parts.