Lionelo Lars Manual De Usuario página 6

Warning
•
The hard parts and plastic parts of the child restraint must be placed
and installed in such a way that, under normal conditions of use of the
vehicle, they cannot be trapped by the sliding seat or door of the vehicle.
•
All straps that secure the restraint to the vehicle must be taut, the straps
that secure the child must be adapted to the child's body and not twisted.
•
Make sure the lap belts run low so that the pelvis is held firmly.
•
If the device was subjected to heavy loads during an accident, it
must be replaced.
•
Do not make any modifications to the seat or install any additional
components without the consent of the competent authorities. To ensure
maximum safety for your child, the equipment must be secured and used in
accordance with the instructions provided in the manufacturer's instructions.
•
The plastic parts of this car seat may heat up in the sun and cause burns
on the skin of the child.
•
Protect the seat against the sun. Otherwise, the seat may be too
hot for your child's skin.
•
Never leave your child unattended in the restraint system.
•
Luggage and other objects that can cause injury in the event of a collision
should be properly secured.
•
Child restraints without upholstery should not be used. It is not
allowed to replace the seat upholstery other than recommended
by the manufacturer, because it is an integral part of the device that
affects its functioning.
•
Keep the seat user manual when using the device. Keep it in the car
where the car seat is installed.
•
Do not use load bearing points of contact other than those described
in the instructions and marked on the child restraint.
•
If you have doubts about the position of the adult seat belt buckle
relative to the main load-bearing points, contact the child restraint
system manufacturer
EN ‑ 6 ‑