Operation; Cleaning And Maintenance - cecotec FORCESILENCE 890 SKYLINE Manual De Instrucciones

4. OPERATION

The fan may be operated by the manual controls located on the fan (as shown in fig 3) or by
your remote control (shown in fig. 2).
1. Place the fan on a stable surface. Plug the cord set into an electrical outlet. Make sure both
outlet and fan power matches the power.
2. Turn the fan on by pressing the Power button; to turn the power Off you just need to press
the same button.
3. You can adjust the fan speed to desired level:
low (LO) – medium (MI) – high (HI) by pressing Speed
The speed setting is displayed on the LED panel (showed in fig.4)
4. Pressing the Mode button will set the fan into:
Eco (EC) – natural (NT) – sleep (SL)
5. The fan is equipped with a timer that allows you to set its length of operation from 0.5 hours
to 7.5 hours.
6. Oscillation (OSC) button will start and stop the oscillation function. The symbol is displayed
on the LED panel.

5. CLEANING AND MAINTENANCE

This can only be done by an authorized service agent such as your local Sealer dealer or any
agent qualified to undertake electrical repairs.
1. Always disconnect the appliance from the mains by switching it off and removing the plug
from the power outlet before cleaning.
2. It is advisable to use a neutral detergent and a soft cloth and to rub dry. Do not use solvents,
acidic detergents, petrol or alcohol etc., to clean the plastic components, as these could be
deformed or damaged.
3. Do not allow water to penetrate the motor during cleaning.
A B C D
(Fig.3)
ENGLISH
E
FORCESILENCE 890 SKYLINE 13