Using The Product; Clock Setting - Becken BMW2327 Manual De Instrucciones

6) Control panel
See below for details (the control panel is subject to change without prior notice)
7) Waveguide cover
It is inside the microwave oven, next to the control panel side.
Caution:
Never remove the waveguide cover.
8) Grill rack
Used to place food for roasting.

2.2. Using the Product

Installation
• Remove all the packing. If there is a safety film over the oven, remove it before
use. Check carefully for damage. If any is found, immediately notify the dealer or
send the appliance to the manufacturer's service center.
• Microwave ovens must be placed in a dry and non-corrosive environment, and
kept away from heat and humidity, such gas burners or water tanks.
• To ensure sufficient ventilation, the distance of the back of the microwave from
the wall should be at least 10 cm. The distance from the side to the wall should be
at least 5 cm. The clearance above the top surface should be at least 20 cm. The
distance of the microwave from the floor should be at least 85 cm.
• The position of the oven must be such that it is far from TVs, radios or antennas
as it may cause interference. The distance should be more than 5 m.
• The appliance must be positioned so that the plug is accessible. It must be
correctly grounded in the event of leakage. A ground loop can be formed to avoid
electric shock.
• The microwave oven must be operated with the door closed.
• The microwave oven must not be placed in a cabinet. The microwave oven is
intended to be used freestanding.
• The back of the oven must be placed against a wall.
• As there may be manufacturing residue or oil still inside the oven or on the heating
element at first, there will be an odor or even a little smoke. This is normal and will
stop after several uses. Keep a door or window open to provide good ventilation.
It is strongly recommended to set the oven to grill mode and heat when empty
several times.
Using the control panel
Before Cooking
The LED flashes 3 times when the oven is plugged in to the power supply. Then it
flashes ":", prompting you to input the cooking program and time.
Time/Weight knob
You can increase or decrease cooking time and weight during use by turning the Time/
Weight knob.
8
Pause/Cancel
At the initial or input stage: press once to cancel input
programs and resume initial stage.
During cooking: press once to stop the oven, press
twice to cancel cooking programs.
Auto Reminder
When your preset cooking procedure has finished,
the LED display will show End and three beeps will be
issued to prompt you to take out the food. If you do not
press the Pause/Cancel button once or open the door,
the beep will be repeated at intervals of 3 minutes.
Instant Cooking
In standby mode, press the Instant/Start button, the
oven will start express cooking at high power; the
default cooking time is one minute. You can increase or
decrease the cooking time by turning the Time/Weight
knob.

Clock Setting

The clock button is available for you to input the
current time or a preset time when ":" flashes on the
LED display after the oven is plugged in. This is not
mandatory and can be skipped if not needed.
Example: to set 12:30
Steps
1 After powering up, the ":" flashes
2 Press and hold the Defrost/Clock button for 3 seconds
3 Turn the Time/Weight knob to set exact hours.
4 Press the Defrost/Clock button again.
5 Turn the Time/Weight knob to set exact minutes.
6 Press the Defrost/Clock button once again or wait for 5 seconds
for the time to stop flashing.
This button has two functions: setting the clock and setting the defrost program. If you
want to set the clock, you must press and hold this button for 3 seconds, to defrost
press the button once.
Microwave Cooking
This function is for cooking and heating food. Press the Micro Power button, the LED
cycles to show 100P — 80P — 60P — 40P — 20P.
Caution
• The max time that can be set is 60 minutes.
• Never use the grill rack during microwave cooking.
Microwave Oven | Horno Microondas | Forno Microondas
EN
Display
:
0:00
12:00
12:00
12:30
9