Idiomas disponibles
Idiomas disponibles
Following the user instruction of the product and the inspection sheet, and without specific tools or a particular measuring device. Observe and touch each component of the product in
order to detect possible anomalies. If one of the checkpoints is defective, the product must be withdrawn from service and replaced by a compliant device, or must be returned either to
Kratos Safety or to an authorized service centre, in order to have the repairs performed
Complete a visual check of the lifeline's appearance: it must be possible to inspect it
Tension indicator: Separately check the condition and presence of each tension indicator component: no defects
1
such as wear, nicks, cuts or deformation or signs of chemicals, cement, paint, etc. that could impair operation or
strength may be present.
Remove the black protective caps and, based on the above criteria, check the condition of nuts, Belleville washers
and assembly welds.
A
Pins
D
Tension indicator washer
G
Belleville washer
Tensioner: Separately check the condition of each tensioner component: no defects such as wear, nicks, cuts or
2
deformation or signs of chemicals, cement, paint, etc. that could impair operation or strength may be present.
Pay particular attention to the rope's path through the pulley.
I
Main tension control bolt
L
Cam
O
Pulley/Rope path
Operation: With no tension on the rope, check pulley rotation, verify the cam and cam lever are working by
3
moving them and check that the plates rotate and lock using the locking knob.
Brass end swivel: Separately check the condition of each end swivel component: no defects such as wear, nicks,
4
cuts or deformation or signs of chemicals, cement, paint, etc. that could impair operation or strength may be
present. Check that all parts rotate freely.
Cross-over anchors (depending on the model): Check the condition of each cross-over anchor: no defects such
5
as wear, nicks or cuts or signs of chemicals, cement, paint, etc. that could impair operation or strength of the
anchors may be present. Make sure the anchors cross over one another freely.
O-ring anchors (depending on the model): Check the condition of each O-ring: no defects such as wear, nicks or
6
cuts or signs of chemicals, cement, paint, etc. that could impair operation or strength of the O-rings may be
present.
End knot: Check the condition and existence of the end knot; it consists of a knot protected by a heat-shrink
7
sleeve.
Polyester rope: Check the condition of the rope along its entire length: no defects such as wear, nicks, cuts, burns,
8
damaged or fraying threads, discolouration, variation in flexibility or signs of chemicals, cement, paint, etc. that
could impair the strength of the rope may be present.
Marking: Check that markings are present and legible.
9
Connector: Check the connector verification sheet.
10
Overall condition: Evaluate the overall condition, keeping the above inspections in mind as well as the product's
general appearance.
Kratos Safety 689 Chemin du Buclay, 38540 Heyrieux France Tel.: +33 (0)4 72 48 78 27
Personal Protective Equipment Inspection Guide
TEMPORARY 4-PERSON LIFELINE - Visual/functional verification (EN)
The use of this document for periodic inspection is reserved for competent persons.
.
B
Rings
E
Protective caps
H
Assembly welds
J
Locking knob
M
End plate
P
Positioning bolts
K
Cam lever
N
Pulley plate
Q
Assembly screws
Fax: +33 (0)4 72 48 58 32
C
Clevises
F
Nuts
