brondell MBH-10 Manual De Instrucciones página 8

PRODUCT INSTALLATION
Installation
Installing the Hand-Held Bidet Holster
1. Install Hand-Held Bidet Holster on Toilet
a. Place Hand-Held Bidet Holster on the toilet so the
mounting slots line up with the holes in the toilet
fixture.
b. Replace the toilet seat on top of Hand-Held Bidet
Holster and secure using original toilet seat
hardware. Make sure to tighten so that the holster
and seat do not move.
2. Connect Cold Water Hose to Hand-Held Bidet Holster
Attach the open end of the Cold Water Braided Metal
Bidet Hose to the incoming water connection on the
side of the holster.
3. Connect Hand-Held Bidet Sprayer to Holster
a. Connect your hand-held bidet sprayer to the
sprayer hose.
b. Connect the open end of the sprayer hose to the ½"
connection at the bottom of the holster.
c. Place the hand-held bidet sprayer in the holster slot.
4. Turn on Water Supply & Check for Leaks
a. Open the main water supply valve slowly and check
for leaks.
b. Wait 5-10 minutes, check again, and if there are no
leaks, continue.
NOTE: If there is any leaking, check all rubber washers
and make sure all water connections are tight and
secure. If necessary, you can use plumbers tape for any
leaking connections.
6
Step 1a
Step 1b
Step 2
Step 3b