Worx Professional WU286 Traducción De Las Instrucciones Originales página 7

Symbols
To reduce the risk of injury, user must read instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return exhausted batteries to
your local collection or recycling point
All manuals and user guides at all-guides.com
7
Operating instructions
Note: Before using the tool, read the instruction book
carefully.
INTeNded Use
This tool is intended for the fastening and loosening of bolts, nuts and
various threaded fasteners. This tool is not intended for use as a drill.
BeFORe PUTTING INTO OPeRATION
• BATTERY CHARGING
The battery charger supplied is matched to the Li-ion battery installed
in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to cool
down before recharging.
When the battery is charged for the first time and after prolonged
storage, the battery will only accept approximately 60% charge.
However, after several charge and discharge cycles the battery will
accept a 100% charge.
• TO REMOVE OR INSTALL BATTERY PACK (See A)
Depress the battery pack release button to release and slide the
battery pack out from your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be sufficient.