Idiomas disponibles
Idiomas disponibles
Page 2
6. Cut the flexible PVC hose that is attached to the
union fitting without the o-ring 3" (8 cm) from the
plastic tee pipe in the canister. Note: The union
fitting with the o-ring will be attached to the new jet
body.
NOTE Do not cut the plastic tee pipe that is cemented
to the bottom of the canister. This tee pipe is a
nonstandard pipe size that will not fit standard
fittings and reducers.
7. Glue a standard PVC 1/2" (1.5 cm) slip cap to the
end of the cut PVC hose using PVC cement.
8. Screw the union fitting with the o-ring directly on
the union fitting of the flexible hose attached to the
new jet body.
9. Install the laminar jet with LED light by following
Section 4 of the enclosed "Laminar Jet Installation
and Operation Manual" by routing the replacement
LED light cable through the conduit. Tape the end
of the existing fiber optic light cable to the LED
light cable so that the LED light cable can be pulled
through the conduit.
10. Set up and operate the laminar jet by referring to
Section 6.2 through Section 8 of the manual.
B. Retrofitting a Fiberstars
Laminar Jet
1. Remove the cover/housing assembly.
2. Disconnect the water lines and the fiber or LED
cable attached to the jet housing.
3. Using a standard pipe coupler or reducer, glue the
existing water inlet tubing of the canister to the
3/4" (2 cm) pipe spigot that is attached to enclosed
flexible hose assembly. See Figure 1.
NOTE Do not cut the flexible PVC hose or the hose
attached to the new Jet Body. These hoses are
a nonstandard size and will not accept standard
pipe fittings. If you need to reduce the total hose
length as space allows, only cut the old hose.
Figure 1. Flexible Hose 3/4" (2 cm) Pipe Spigot
* or Pentair
**
®
®
3/4" (2 cm) Spigot
Jandy
Laminar Jet with RGBW LED Light Replacement Kit Installation Instructions
®
4. Install the laminar jet with LED light by following
Section 4 of the enclosed "Laminar Jet Installation
and Operation Manual" and by using the existing
fiber optic light cable to pull the new LED light
cable through the conduit.
5. Set up and operate the laminar jet by referring to
Section 6.2 through Section 8 of the manual.
C. Replacement Kit Lists
The following table is for your reference. To order
additional parts, please contact your local distributor.
COMPONENT
DESCRIPTION
1
Complete Laminar Jet
Assembly with LED Light
Module
2
Flexible Hose Assembly
3
Canister Collar, Pebble,
Laminar Jet
4
Canister Lid, Pebble,
Laminar Jet
5
Canister Collar, Pewter,
Laminar Jet
6
Canister Lid, Pewter,
Laminar Jet
7
Screw, 10-24 x 1.125 Flat
Head
8
Instructions
*Fiberstars is a registered trademark of Energy Focus, Inc.
**Pentair is a registered trademark of Pentair, Inc.
1
--
--
1
--
--
--
1
--
--
1
--
--
--
1
--
--
1
--
2
2
1
--
--
