AGV Tourmodular Manual Del Usuario página 7

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
1
1
2
3
10
5.3 REMOVAL
Prerequisite: the visor is fully open. Start the operation
on the right-side visor mechanism.
1
• Pull down the spring slider
with a fin-
gernail, then detach the visor from the
mechanism.
Repeat the operation on the visor mechanism
on the left-side visor mechanism.
5.4 INSTALLATION
Prerequisite: begin the operation on the right-side visor
mechanism.
• Grasp the visor and pull down the spring slid-
1
er
with a fingernail.
• Place the visor on the associated mecha-
2
nism, so that the two engagement tabs
3
are seated into their slots
.
• Release the spring slider.
• Repeat the above operations on the left-side
visor mechanism.
Visor installed. Rotate it, making sure it
is securely attached and the movement is
smooth.
Opening / closing the chinguard without the vi-
sor fitted can cause the come out of the mecha-
nism 3 from its sliding seat.
5.5 MICRO-OPENING
In this position the visor is firmly closed pro-
viding maximum safety, but it creates a gap
of about 5mm to allow a moderate flow of air
inside the helmet.
1
Prerequisite: the visor is open.
Lower the visor until the engagement catch
1
2
first click.
Prerequisite: the visor is closed.
Press the opening button
movement, move the visor slightly upwards
until the engagement catch
visor to the first click.
5.6 CLOSURE ADJUSTMENT
It is possible to adjust the position of the hook-
ing cog, thus changing the pressure thereby
required to the button to open the visor.
Prerequisite: the visor is installed and open, and the
2
helmet is resting on a flat surface. Use a Torx
screwdriver.
• Loosen the screw
• Adjust the position of the engagement catch
2
• Tighten the screw.
Make sure that the visor closes securely.
1
EN
IT
FR
2
engages the opening button
to the
DE
If necessary, facilitate this en-
gagement by pressing the visor
ES
2
open button
lightly.
PT
2
and, in a single
РУ
1
locks the
中文
中文
T7
®
1
.
as desired.
The farther back the catch is posi-
tioned, the more pressure is required
on the button to open the visor.
11
Tabla de contenido
loading

Tabla de contenido