Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11 CROWN PAD
11.1 REMOVAL
Prerequisite: in a seated position, place the helmet upside-down on your knees. Lift the chin guard and lock it.
• Release the two snap buttons 1A by detaching them from the neck area 1B.
• Release the two cheek pads upper snap buttons 2A, to release the fabric headset ring 2B.
›
Release the five front plastic clips of the headset 3A from their seats 3B located in the
front area of the polystyrene shell.
11.2 INSTALLATION
11.2 INSTALLATION
Prerequisite: in a seated position, place the helmet upside-down on your knees. Lift the chin guard and lock it.
• • Place the crown pad inside the helmet with the snap buttons positioned at the back.
Place the crown pad inside the helmet with the snap buttons positioned at the back.
Snap the two rear snap buttons 1A 1A located in the neck area
• • Snap the two rear snap buttons
• • Attach the two upper snap buttons of the pad
Attach the two upper snap buttons of the pad 2A 2A, interposing the crown pad fabric rings
› ›
Attach the five front plastic clips of the headset 3A 3A to their seats
Attach the five front plastic clips of the headset
2B 2B
3A 3A
1A 1A
1A 1A
2B 2B
3A 3A
18
located in the neck area 1B 1B. .
, interposing the crown pad fabric rings 2B 2B. .
to their seats 3B 3B. .
2A 2A
3A 3A
3A 3A
3A 3A
1B 1B
1B 1B
2
12 WIND PROTECTION
12.1 INSTALLATION AND REMOVAL
Prerequisite: in a seated position, rest the helmet on your knees with the chin guard lowered.
›
To install the wind guard, lift the base trim of the chin guard with your fingers and align
the two holes
›
To remove the wind guard, lift the bottom edge of the chin guard with your fingers and pull
the wind guard towards the inside of the helmet, so that the two holes
plastic strip are released from the two hooks
13 NOSE GUARD
13 NOSE GUARD
13.1 INSTALLATION AND REMOVAL
13.1 INSTALLATION AND REMOVAL
Prerequisite: in a seated position, rest the helmet on your knees. Chin guard closed, visor raised.
Prerequisite: in a seated position, rest the helmet on your knees. Chin guard closed, visor raised.
› ›
Place the nose guard in position, first inserting the central clip
Place the nose guard in position, first inserting the central clip
› ›
To remove the nose guard, first detach the side clips
To remove the nose guard, first detach the side clips
3B 3B
3B 3B
3B 3B
3B 3B
3B 3B
2
1
1
2
drilled in the plastic strip with the two hooks
2
located below the bottom edge
1
, then the two side ones
, then the two side ones
2
individually, then the middle clip
individually, then the middle clip
2
1
EN
IT
1
FR
DE
ES
PT
below the base trim.
РУ
1
drilled in the
中文
中文
2
. .
1
. .
2
19
Tabla de contenido
