Internal light
In order to reduce energy consumption, the LED light within this wine wine cooler will
automatically switch off when closed the door. If you would prefer the LED light to remain
on continuously, this is possible. Please press and hold the"
the display will show "LP". After 4 seconds the display will revert back to normal and the
light will remain on until manually switched off.
If you would like to revert back and conserve energy (recommended), press and hold the
"
" button for 5 seconds, the display will show "LF". After 4 seconds the display will
revert back to normal, and the light will automatically switch off after 10 minutes.
(the light will turn on when door open and will turn off when door closed.)
Function Instruction
Temperature Recollection Function
In the event of a power interruption, wine cooler can remember the previous temperature
settings, and when the power is recovery, the cooler temperature will go back the same
setting temperature as power off.
Overtime Open the Door Alarm
When you forget close the door or the door is not closed completely, the buzzer alarm after
1 minutes. Please close the door completely and avoid the cold energy was lost.
Temperature Alarm
If inner temperature is higher than 23° C, The "HI" is shown in display panel, and the
buzzer alarm after one hour continuously. It inform that the inner temperature is too high,
please check the reason.
If inner temperature is lower than 0°C, The "LO" is shown in display panel, and the buzzer
alarm and the malfunction indicator light light at the same time.
Attention
If the unit is unplugged, power lost, or turned off, you must wait 3 to5 minutes before
restart the unit. If you need attempt to restart before this time delay, the Wine Cooler will
not start. If first time use or longer absence of using, the temperature will difference
between setting and LED display temperature. After running a period, the temperature will
be reverting back.
Shelves
According to the actual configuration of your product, please check the relative Remove or
Replace Racks.
To prevent damaging the door gasket, make sure to have the door all the way opened
when pulling shelves out of the rail compartment.
1. Fully extend the shelf you wish to remove (Fig. A)
2. Lift the front of the shelf up (Fig. A)
3. Holding the shelf track, push the shelf in, then up to release from the rear dampers
(Fig. B)
30
"bottom for 5 seconds,