Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
 Temperature Recollection Function
In the event of a power interruption, wine chiller can remember the previous temperature settings, and
when the power is recovery, the cooler temperature will go back the same setting temperature as power off.
 Internal light
In order to reduce energy consumption, this wine cabinet will automatically switch off the LED lights after 10
minutes.
If you want the LED light to remain on continuously, this is possible. Please press and hold the "LIGHT" button
for 5 seconds, the display will show "LP".After 4 seconds the display will revert back to normal and the light will
remain on until manually switched off.
If you want to revert back and conserve energy (recommended), please press and hold the "LIGHT" button for 5
second, the display will show "LF",after 4 seconds the display will revert back to normal, and the light will
automatically switch off after 10 minutes.
 Shelves
To prevent damaging the door gasket, make sure to have the door all the way opened when pulling
shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail
compartment, however this unit was designed with a notch on each sides of the shelf tracks to prevent
bottles from falling.
When removing any of these shelves out of the rail compartment, To fit or remove the shelf, tilt the shelf
as per the diagram and simply pull out, or push in the shelf until it sits on the support brackets securely.
NOTE:
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit.
If you attempt to restart before this time delay, the Wine cooler/beverage cooler will not start.
 When you use the Wine cooler/beverage cooler for the first time or restart the Wine cooler/beverage
cooler after having been shut off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED readout. This is normal and it is due to the
length of the activation time. Once the Wine cooler/beverage cooler is running for a few hours
everything will be back to normal.
30
Tabla de contenido
loading

Tabla de contenido